Tyres need the right amount of air to ensure safety and longevity. Following the manufacturer's recommendations for tyre inflation has a positive effect on the bike's performance.
Tyres gradually lose air so it is essential to check tyre pressure before you set out. If you check your tyres during your journey, you will be checking 'warmed up' tyres. In effect, the pressure builds up whilst on the road, so you should never let down a tyre that has just been used.
If the tyre pressure is below that recommended by the manufacturer, you should top up the air. The pressure should be more than 0.3 bars higher than the recommendation for a tyre starting from cold.
Once you have checked the tyre pressure, don't forget to replace the cap on the valve to ensure no water gets in to the core of the valve. We recommend you change the valve and cap every time you replace a tyre as it is an essential part of the seal.
These are the tyre pressures recommended by Michelin depending on the terrain,
the weather conditions, the power of the bike and the type of control:
Invented by MICHELIN and intended for Cross Country, Rally, Enduro and MX use, Bib Mousse is:
The maximum speed with a tyre using MICHELIN Bib Mousse is 130kph (80mph). It carries the letters NHS (Not for Highway Service). Consequently, it should not be used on the public highway.
MICHELIN Bib Mousse should not be kept long term at temperatures above 30°C and it is best to avoid temperatures above 40°C altogether.
It can be used for a maximum of 6 months after fitting, however the lifespan of MICHELIN Bib Mousse varies considerably depending on the intensity of usage and the discipline practised. For example, it will be much shorter for Motocross than for Enduro.
Before a fast stage, we recommend you warm up the tyre and the MICHELIN Bib Mousse progressively at a moderate speed.
Apply Michelin gel every time you put on or take off a MICHELIN Bib Mousse, both new and used, to prolong its life and avoid excessive overheating.
Your tyres should be kept somewhere ventilated, dry and temperate, out of direct sunlight and away from temperature extremes, all chemicals, and any solvent or hydrocarbon which might affect the rubber. They should also be kept well away from anything that might pierce the rubber (for instance sharp metal or wood) and away from direct heat or electrical charges.
The design of Trial tyres makes them tricky to mount. You run the risk of breaking bead wires if you press too hard. Carefully adhere to the fitting instructions for insertion of the rim hooks (lubricate, firmly hold the bead on the opposite side in the rim hollow - do not exert excessive force on the bead). To inflate, position a rubber ring between the tyre bead and rim or use a firmly tightened strap on the tyre crown to enable initial pressurising.
The tread provides most of the tyre's grip on the ground. With wear, the tyre's grip decreases. So remember to regularly check your tyres for signs of wear: visually check the depth of the tread and the uniformity of the wear. Tyre pressure also has a direct impact on wear.
For the Enduro, Desert, S12XC and M12XC ranges the classification is determined by the width of the tyre at the tread.
As for the Starcross, AC10 Trial Light and Xlight ranges, the name is based on the width of the tyre measured at the sidewall level.
So a 130/70-19 Cross Competition S12XC corresponds to a 110/90-19 Starcross 5.